11
Getting Started
Starting the SDC3 System
1� Press the power button located at the bottom left corner of the front panel to set the power
to ON�
2� As the system starts up, the SDC3 shows the welcome screen�
3� The version of the SDC3 software shows under the SDC3 logo�
4� Loading progress shows at the bottom of the screen�
5� To shut down the system, press the power button again�
Logging in as an Operator or Administrator
If the SDC3 has Access Control enabled, you must log in when the SDC3 starts up�
1� If you have Administrator permission, check the Administrator box�
2� Enter your name in the Operator Name eld�
3� Enter the password in password eld�
4� Press the LOGIN button� After successful log in, the system shows the Home screen�
The Home Screen
After the SDC3 starts up, the Home Screen displays� The Home Screen has links to the primary
functions of the SDC3� From the Home Screen, you can:
• Start a new patient case
• Access current patient cases
• Access archived patient information
• Load patient information into the system
• Adjust system settings
• Change surgeon proles
• Change operators (if Access Control is enabled)
1� Press the SETTINGS
button to go to the SDC3 Settings screens�
2� Press the NEW CASE
button to start a new patient case�
• If a patient case has already been started, but there is no data saved to that case,
the system asks, “Do you wish to discard the current case?”
• If a patient case has already been started, and there is data saved to that case, the
system asks, “Do you wish to create a new case?”
• Press EXIT
to go back to the Home screen� Press OK
to go to the New
Case screen�
3� Press the CURRENT CASE button to go to the Current Case screen�
4� Press the ARCHIVE button to go to the Archived Cases screen, which shows cases that
have been saved to the SDC3, a USB storage device, a disc, or the Studio3 media server�
5� Press the LOAD PATIENT INFO button to go to the Patient Info screen and preload
patient information before surgery�