Stryker SDC3 - Server and Integration Settings

75
Server Settings
Settings for how the SDC3 interacts with the Studio3 Server, the DICOM server, Stryker Link and
Cloud Integration are accessible from the SERVER tab�
Studio3 Server Settings
1
7
8
9
2
3 4
5
6
1� Go to the Server tab, then select the STUDIO3 tab to go to the Studio3 Server Settings
screen�
2� Enter the Studio3 server IP address in the IP Address eld�
3� Enter the Studio3 server Port number in the Port eld�
4� Press the ECHO button to test the Studio3 server connection� Valid server credentials are
conrmed by an “Echo Successful” message shown in the status bar�
5� Select the Allow Deletion of Pending Cases checkbox to allow deletion of pending cases
from the Studio3 archive list�
6� Set the amount of times the SDC3 attempts to transfer data to the Studio3 server in the
Maximum Transfer Attempts eld� The default value is ve attempts�
7� The dropdown menu lists available FTP Buer Sizes�
8� The default Max Queue Size is 1000� Alternate values can be entered in this eld�
9� Press the SAVE button to save settings�