Stryker SDC3 - Save Settings for Powershare

79
To connect the SDC3 to your facility’s PowerShare network:
Note: Cloud Integration must be ON to connect to the PowerShare Network. To set up Cloud
Integration, contact your Stryker representative.
1� Go to Settings > Server > Cloud Settings�
2� Press the SETUP button under PowerShare Integration�
3� Enter your PowerShare User ID and Password�
4� To test the connection, press VALIDATE� If the connection is successful, the SDC3 shows the
message, “Authentication successful�”
5� To save the connection, press SAVE�
Save Settings for PowerShare
To enable saving case information to PowerShare:
1� Go to Current Case > Save�