Stryker SDC3 User Manual

83
Print errors Make sure there aren’t any paper jams�
Make sure the printer has enough ink�
Make sure the printer door is closed�
Make sure the printer has paper�
Make sure the printer is powered on�
Make sure the printer cable is connected��
Error saving more than 4GB les
to the USB
Make sure that the USB is formatted as NTFS� FAT 32 will not
support any le size bigger than 4GB�
Error reading archived cases
from DVD/CD
Reboot the system if you have just written the case� Check
the disc on a dierent system�
No videos written to the USB Make sure “write videos to USB” in the save settings is
selected�
No videos written to the
network
Make sure “write videos to Network” in the save settings is
selected�
Annotation list is blank Make sure that a procedure is selected in the Patient
information screen in order to enable the annotation list�
Device status overlays do not
appear on the surgical display
Make sure proper connections have been made between
devices and device ports on the SDC3�
Make sure the device is selected/added in the “Video
Settings: On-Screen Display” menu�
Touchscreen controls are not
working properly
Go to Settings > General� Press the CALIBRATE button to
calibrate the touchscreen�
The SDC3 does not recognize
the iPad
Unplug the iPad from the USB drive, then plug it back in�
Make sure to wait at least 30 seconds for the iPad to
connect�
The SDC3 does not recognize an
SFB/FireWire device�
1� Set the SDC3 power to o�
2� Connect the SFB/FireWire cable to both the device and
the SDC3�
3� Set the SDC3 power to on�

Stryker SDC3 Specifications

General

Brand	Stryker
Model	SDC3
Category	Medical Equipment
Language	English