Chapter 5 Servicing Infrastructure Boards and Components 5-23
d. Remove the top cover.
See Section 2.8, “Removing the Top Cover” on page 2-10.
e. Attach an antistatic wrist strap.
See Section 2.7, “Performing Electrostatic Discharge and Antistatic Prevention
Measures” on page 2-8.
2. Remove the card in the PCIe 0 riser for better access (Optional).
3. Untwist the cable tiedowns to release the cables (
FIGURE 5-14).
4. Depress the latch on the single headed cable and then disconnect the cable from
the motherboard.
5. Pull up on each of the three individual connectors on the other cable.
6. Remove the fans from fan board 0.
7. Disconnect each cable at drives backplane by depressing the latch and then
pulling out the connector.
8. Remove the cables.
Do not snag the cables on the retainer above the mid-wall.
To Next Page
Loading...
