Sun Microsystems Sun Fire X4150 - Extending the Server to the Maintenance Position

Chapter 2 Preparing to Service the System 2-5
8. Type:
stop /SYS
or
cd /SP/CtrlInfo
set powerctrl=off
2.5 Extending the Server to the Maintenance
Position
The following components can be serviced with the server in the maintenance
position:
■ Hard drives/SSDs
■ Fan modules
■ Power supplies
■ DVD/USB module
■ Fan power boards
■ FB-DIMMs
■ PCIe cards
■ Motherboard battery
If the server is installed in a rack with extendable slide rails, use this procedure to
extend the server to the maintenance position.
1. (Optional) Issue the following command from the -> prompt to locate the
system that requires maintenance.
After you have located the server, press the Locator LED/Locator button to turn it
off.
2. Verify that no cables will be damaged or will interfere when the server is
extended.
Although the cable management arm (CMA) that is supplied with the server is
hinged to accommodate extending the server, you should ensure that all cables
and cords are capable of extending.
-> set /SYS/LOCATE status=on
Locator indicator is on.