3-4 Sun Fire X4150 Server Service Manual • November 2009
Note – You can create RAID volumes with SAS hard drives and SATA SSDs, as long
as you do not mix them in a same volume.
The following cable kits are used for the HBA controller when using hard drives and
SSDs:
3.2.2.1 SSD Minimum Required Firmware
BIOS/ILOM Firmware
■ BIOS: 1ADQW060
■ ILOM: 3.0.3.37
Adaptec Firmware
■ Adaptec FW: 16732
■ LSI FW: 1.27.02, MPTBIOS: 6.26.00
SSD firmware
■ Intel SSD FW: 845C8626
3.2.3 Drive Status LED Reference
FIGURE 3-2 shows the hard drive and SSD LED status indicators.
FIGURE 3-2 Drive Status LEDs
TABLE 3-3 Sun Fire X4150 Cable Kits
Cable Kit Order Number Comments
SSD without HBA 6389A Connects up to 4 SSDs
SAS/SATA with HBA 6388A Connects up to 8, no more than 4 can be
SSDs
To Next Page
Loading...
