2-2 Sun Fire X4150 Server Service Manual • November 2009
For your protection, observe the following safety precautions when setting up your
equipment:
■ Follow all Sun cautions, warnings, and instructions marked on the equipment and
described in Important Safety Information for Sun Hardware Systems (816-7190).
■ Follow all cautions, warnings, and instructions marked on the equipment and
described in the Sun Fire X4150 Server Safety and Compliance Guide.
■ Ensure that the voltage and frequency of your power source match the voltage
and frequency inscribed on the equipment’s electrical rating label.
■ Follow the electrostatic discharge safety practices as described in this chapter.
2.2 Required Tools
The Sun Fire X4150 Server can be serviced with the following tools:
■ Antistatic wrist strap
■ Antistatic mat
■ No. 2 Phillips screwdriver
■ No. 1 flat-blade screwdriver (for battery removal)
■ Stylus or pencil (to power on server)
2.3 Obtaining the Chassis Serial Number
To obtain support for your server, you need your chassis serial number. The chassis
serial number is located on a sticker on the front of the server, and another sticker on
the top of the server.
Note – You might be asked for your hardware serial number if you need service for
your system. To find the serial number of your system, use the ILOM command get
/SYS or see your Installation Guide or Service Manual.
To Next Page
Loading...
