Contents vii
5.6.1 Removing the Paddle Card 5–17
5.6.2 Installing the Paddle Card 5–17
5.7 Servicing Cables 5–18
5.7.1 Removing Drive Cables in a SAS Configuration 5–19
5.7.2 Installing Drives Cables in a SAS Configuration 5–20
5.7.3 Removing Drive Cables in a SATA Configuration 5–22
5.7.4 Installing Drive Cables in a SATA Configuration 5–24
5.7.5 Changing Drive Cables from SAS to SATA 5–26
5.7.6 Change Drive Cables from SATA to SAS 5–27
5.7.7 Converting From SAS Configuration To SSD Configuration 5–27
5.7.8 Removing a PDB Cable 5–28
5.7.9 Installing a PDB Cable 5–30
6. Returning the Server to Operation 6–1
6.1 Installing the Top Cover 6–2
6.2 Reinstalling the Server in the Rack 6–3
6.3 Returning the Server to the Normal Rack Position 6–5
6.4 Powering On the Server 6–6
A. Connector Pinouts A–1
A.1 Serial Management Port Connector A–2
A.2 Network Management Port Connector A–3
A.3 Video Connector A–4
A.4 USB Connectors A–5
A.5 Gigabit Ethernet Connectors A–6
B. BIOS Power-On Self-Test (POST) Codes B–1
B.1 Introduction B–1
B.2 How BIOS POST Memory Testing Works B–2
B.3 Redirecting Console Output B–2
To Next Page
Loading...
Need help?
General
