1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-82
Global Settings
Clicking the GLOBAL SETTINGS tab brings up the GLOBAL CONFIGURATION page
(Figure 5-66), which allows you to configure RSTP global parameters. The parameters
for this page are shown in Table 5-50.
Figure 5-66. Global Configuration Page
Table 5-50. Global Configuration Page Parameters
Parameter Description
Bridge Priority
This parameter specifies the Priority value assigned to the bridge that is used to
select the root bridge. The allowed value ranges from 0 to 61440. The default
priority value is 32768.
Path Cost Type
This parameter allows configuration of the Path Cost Type to either 16 Bit or 32
Bit.
Protocol Version This allows you to configure the Protocol Version as either RSTP or MSTP.
Dynamic Path Cost
Calculation
This parameter allows you enable or disable the dynamic path cost calculation.
To Next Page
Loading...
