1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-98
Table 5-62. LLDP Global Settings Page Parameters
Parameter Description
LLDP Status This parameter allows you to Enable or disable the LLDP status.
Transmit Interval
This parameter specifies the transmission frequency of LLDP updates in
seconds. The allowed values are from 5 to 32768. The default is 30 seconds.
Holdtime Multiplier
This parameter specifies the multiplier value (value which is used to calculate the
Time-To-Live for the LLDP advertisements). The allowed values are from 2 to 10.
The default value is 4.
Reinitialization Delay
This parameter specifies the re-initialization delay (delay time taken by LLDP to
re-initialize on any interface). The allowed values are from 1 to 10. The default is
2 seconds.
Transmit Delay
This parameter specifies the transmit delay (minimum amount of delay between
successive LLDP frame transmissions). The allowed values are from 1 to 8192.
The default is 2 seconds.
Notification Interval
This parameter specifies the notification interval (interval at which LLDP
notifications are sent to NMS). The allowed values are from 5 to 3600. The
default is 5 seconds.
Chassis-ID Subtype
With this parameter you can choose the Chassis-ID subtype either as a Chassis
Component, a Port Component, a MAC address, a Network Address, an
Interface Name or as Locally Assigned.
To Next Page
Loading...
