Supermicro SSE-X3348S - Page 151

5-99
Chapter 5: Web Based Management Utility
Interface Settings
Clicking the INTERFACE SETTINGS tab brings up the LLDP PORT SETTINGS page
(Figure 5-80), which helps you to configure LLDP global parameters. The parameters
for this page are shown in Table 5-63.
Figure 5-80. LLDP Port Settings Page
Table 5-63. LLDP Port Settings Page Parameters
Parameter Description
Port This parameter specifies the Port number
Tx/Rx
This parameter helps to configure either Transmit and Receive(Tx+Rx),
Transmit(Tx), Receive (Rx) or None.
Notification
This parameter helps to configure either Disabled, Remote Change, Mis Config
or Both.
Port ID Subtype
This parameter helps to choose a PortId subtype as either Interface Alias, Port
Component, Mac Address, Interface Name or Locally Assigned.
Below fields are under Basis TLV.
Port This parameter specifies the port as either Yes or None.
SysName This parameter specifies the system name as either Yes or None.
SysDesc This parameter specifies the system description as either Yes or None.
SysCapab This parameter specifies the system capability as either Yes or None.