Engine Mechanical: 1D-65
2) Check the corresponding crankshaft journal O.D.
codes ([A], [B] or [C]) “B”, which are stamped on the
crankshaft.
3) Measure the crankshaft O.D. with the special tool. If
any of the measurements are out of specification,
replace the crankshaft.
Crankshaft journal O.D. specification
Special tool
(A): 09900–20202 (Micrometer (25-50mm))
4) Select the specified bearings from the bearing
selection table.
Bearing selection table
Bearing thickness specification
Code “B” O.D. specification
A
35.992 – 36.000 mm
(1.4170 – 1.4173 in)
B
35.984 – 35.992 mm
(1.4167 – 1.4170 in)
C
35.976 – 35.984 mm
(1.4164 – 1.4167 in)
“B”
I649G1140339-01
(A)
I649G1140340-02
Crankshaft O.D. “B”
Code A B C
Crankcase
I.D. “A”
A Green Black Brown
BBlackBrownYellow
Color (Part No.) Thickness
Green
(12229-06B00-0A0) (1)
(12229-06B10-0A0) (2)
1.486 – 1.490 mm
(0.0585 – 0.0587 in)
Black
(12229-06B00-0B0) (1)
(12229-06B10-0B0) (2)
1.490 – 1.494 mm
(0.0587 – 0.0588 in)
Brown
(12229-06B00-0C0) (1)
(12229-06B10-0C0) (2)
1.494 – 1.498 mm
(0.0588 – 0.0590 in)
Yellow
(12229-06B00-0D0) (1)
(12229-06B10-0D0) (2)
1.498 – 1.502 mm
(0.0590 – 0.0591 in)
1. Grooved bearing with oil hole (For lower crankcase)
2. Grooved bearing (For upper crankcase)
“C”: Color code
Upper
Lower
1 2
“C”
1 1 1 11 1
222222
I649G1140341-02
To Next Page
Loading...
