Suzuki 2005 GSF1200 - Fuel Filter Inspection and Cleaning; Fuel Level Gauge Removal and Installation

Fuel System: 1G-15
• Tighten the fuel valve mounting bolts to the specified
torque.
Tightening torque
Fuel valve mounting bolt (a): 4.4 N·m (0.44 kgf-m,
3.2 lb-ft)
Fuel Filter Inspection and Cleaning
B649G11706021
Inspect and clean the fuel filter in the following
procedures:
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation: ”.
2) Remove the fuel valve. Refer to “Fuel Valve
Removal and Installation: ”.
3) Check the fuel filter for sediment or rust.
If the fuel filter is dirty with sediment or rust, fuel will
not flow smoothly and loss in engine power may
result. Clean the fuel filter with compressed air.
4) Reinstall the fuel valve. Refer to “Fuel Valve
Removal and Installation: ”.
5) Reinstall the fuel tank. Refer to “Fuel Tank Removal
and Installation: ”.
Fuel Level Gauge Removal and Installation
B649G11706022
Removal
WARNING
!
Gasoline is very explosive. Extreme care
must be taken.
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation: ”.
2) Remove the fuel level gauge (1).
3) Remove the O-ring (2).
Installation
Install the fuel level gauge in the reverse order of
removal. Pay attention to the following points:
WARNING
!
Replace the O-ring (1) with a new one to
prevent fuel leakage.
(a)
I649G1170018-01
I649G1170020-01
1
I649G1170021-01
2
I649G1170022-01
1
I649G1170024-02