Suzuki 2005 GSF1200 - Reflex Refrector Construction; Turn Signal; Side-Stand Relay Inspection; Turn Signal; Side-Stand Relay Removal and Installation

9B-10 Lighting Systems:
Reflex Refrector Construction (For E-24, 28)
B649G19206025
Turn Signal / Side-stand Relay Inspection
B649G19206026
Refer to “Electrical Components Location: in Section
0A”.
NOTE
Make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are
OK, the turn signal relay may be faulty; therefore,
replace the turn signal/side-stand relay with a new one.
Refer to “Turn Signal / Side-stand Relay Removal and
Installation: ”.
Turn Signal / Side-stand Relay Removal and
Installation
B649G19206027
Removal
1) Remove the left frame cover. Refer to “Exterior Parts
Removal and Installation: in Section 9D”.
2) Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse
order of removal.
(a)
1,
(a)
(b)
2
1
3
Front side Rear side
I649G1920035-04
1. Reflex refrector 3. Rear fender : 4.5 N⋅m (0.45 kgf-m, 3.25 lb-ft)
2. Front fork : 1.8 N⋅m (0.18 kgf-m, 1.3 lb-ft)
1
I649G1190024-01