Suzuki 2005 GSF1200 - Seat Height Adjustment

9D-8 Exterior Parts:
Installation
Install the cowling and cowling brace in the reverse order
of removal. Pay attention to the following point:
• After installing, be sure to inspect the headlight beam.
Refer to “Headlight Beam Adjustment: in Section 9B”.
Front Fender
Refer to “Front Fork Removal and Installation: in
Section 2B”.
Seat Height Adjustment
B649G19406005
Adjust the seat height in the following procedures:
1) Remove the seat assembly. Refer to “Exterior Parts
Removal and Installation: ”.
2) Remove the seat height adjust dampers.
3) Remove the front seat from the rear seat.
4) Adjust the seat height adjuster position “A” or “B”.
5) Reinstall the front seat and adjust the seat height
adjuster position “A” or “B”.
6) Install the seat height adjust dampers.
NOTE
Dampers are used in two ways “A” or “B”.
Pay attention to the direction of dampers
when installing them.
CAUTION
!
Position of adjuster and direction of dampers
must be unified either “A” or “B”.
7) Install the seat assembly. Refer to “Exterior Parts
Removal and Installation: ”.
“A”: For low (Normal) position “B”: For high position
I649G1940024-01
I649G1940025-01
“A”
“B”
I649G1940026-01
“A”: For low (Normal) position “B”: For high position
“A”: For low (Normal) position
“B”: For high position
A
B
A
B
I649G1940027-02
“A”
“A”
I649G1940028-02
“B”
“B”
I649G1940030-01