Suzuki 2005 GSF1200 - Oil Pan; Oil Sump Filter Cleaning; Oil Pressure Switch Removal and Installation

1E-6 Engine Lubrication System:
3) Install the oil pressure regulator. Refer to “Oil Pan /
Oil Sump Filter / Oil Pressure Regulator Removal
and Installation: ”.
Oil Pan / Oil Sump Filter Cleaning
B649G11506025
Refer to “Oil Pan / Oil Sump Filter / Oil Pressure
Regulator Removal and Installation: ”.
Oil Sump Filter
Clean the oil sump filter using compressed air.
Oil Pan
Wash the oil pan with kerosine.
Oil Pressure Switch Removal and Installation
B649G11506026
Refer to “Electrical Components Location: in Section
0A”.
Removal
1) Drain engine oil. Refer to “Engine Oil and Filter
Replacement: in Section 0B”.
2) Remove the CKP sensor cover. Refer to “CKP
Sensor Removal and Installation: in Section 1H”.
3) Disconnect the oil pressure switch lead wire.
4) Remove the oil pressure switch.
Installation
1) Install the oil pressure switch, apply the SUZUKI
BOND to its thread and tighten it to the specified
torque.
: Sealant 99000–31140 (SUZUKI Bond
1207B or equivalent)
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10.0
lb-ft)
I649G1150010-01
I649G1150011-02
I649G1150012-01
I649G1150013-01
(a)
I649G1150014-01