Suzuki 2005 GSF1200 - Starter Clutch Components; Starter Clutch Removal and Installation

1I-12 Starting System:
3) Check the continuity between Blue and Black/White
lead wires with the transmission in “NEUTRAL”.
CAUTION
!
When disconnecting and connecting the gear
position switch coupler, make sure to turn off
the ignition switch, or electronic parts may
get damaged.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
4) Connect the gear position switch coupler to the
wiring harness.
5) Install the seat. Refer to “Exterior Parts Removal and
Installation: in Section 9D”.
Starter Clutch Components
B649G11906018
Starter Clutch Removal and Installation
B649G11906019
Removal
1) Remove the starter motor. Refer to “Starter Motor
Removal and Installation: ”.
2) Drain engine oil.
3) Remove the starter clutch cover.
Bl
G/Bl
R/B
B/W
I649G1190048-01
ON (Neutral)
OFF (Except neutral)
BI B/W
I649G1190045-02
1. Starter idle gear 4. Starter clutch
2. Shaft : 150 N⋅m (15.0 kgf-m, 108.5 lb-ft)
3. Starter driven gear : Apply thread lock to thread part.
1
2
(a)
3
4
I649G1190049-01
I649G1190032-03