Suzuki 2005 GSF1200 - Rear Sprocket; Rear Sprocket Mounting Drum Removal and Installation

Drive Chain / Drive Train / Drive Shaft: 3A-3
• Apply a small quantity of THREAD LOCK “1342” to
the speed sensor rotor bolt (3).
: Thread lock cement 99000–32050 (Thread
Lock Cement 1342 or equivalent)
• Tighten the speed sensor rotor bolt (3) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 20 N·m (2.0 kgf-m,
14.5 lb-ft)
• Before installing the engine sprocket cover, apply a
small quantity of SUZUKI SUPER GREASE “A” to the
clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the gearshift lever to the gearshift shaft in the
correct position.
Gearshift lever height “a”
Standard: 55 mm (2.2 in)
• Adjust the drive chain slack. Refer to “Drive Chain
Inspection and Adjustment: in Section 0B”.
Rear Sprocket / Rear Sprocket Mounting Drum
Removal and Installation
B649G13106009
Removal
1) Remove the rear wheel assembly by disengaging
the drive chain. Refer to “Rear Wheel Assembly
Removal and Installation: in Section 2D”.
2) Remove the spacer (1).
3) Remove the rear sprocket nuts and separate the
rear sprocket (2) from its mounting drum (3).
4) Draw out the mounting drum (3) from the wheel hub.
5) Remove the retainer (4).
6) Remove the wheel dampers (5).
(b)
3,
I649G1310008-03
“a”
I649G1310009-02
2
1
3
I649G1310010-02
4
I649G1310011-01
5
I649G1310012-01