Starting System: 1I-15
Starter Button Inspection
B649G11906021
Inspect the starter button in the following procedures:
1) Remove the right frame head cover. (GSF1200)
Refer to “Exterior Parts Removal and Installation: in
Section 9D”.
2) Disconnect the right handlebar switch coupler (1).
3) Inspect the starter button for continuity with a tester.
If any abnormality is found, replace the right handle
switch assembly with a new one. Refer to
“Handlebars Removal and Installation: in Section
6B”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the starter button inspection, reinstall
the removed parts.
1
I649G1190047-02
I649G1190044-01
To Next Page
Loading...
