Drive Chain / Drive Train / Drive Shaft: 3A-5
Sprocket Mounting Drum Dust Seal / Bearing
Removal and Installation
B649G13106011
Removal
1) Remove the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation: in
Section 2D”.
2) Remove the mounting drum from the rear wheel hub.
3) Remove the spacer and retainer. Refer to “Rear
Sprocket / Rear Sprocket Mounting Drum Removal
and Installation: ”.
4) Remove the sprocket mounting drum dust seal using
the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
5) Remove the sprocket mounting drum bearing using
the special tool.
Special tool
(B): 09913–70210 (Bearing installer set)
Installation
CAUTION
!
The removed dust seal and bearing must be
replaced with new ones.
1) Apply grease to the bearing before installing.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
2) Install the bearing and dust seal to the sprocket
mounting drum using the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
3) Apply grease to the dust seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
4) Install the spacer and retainer.
5) Install the mounting drum to rear wheel hub. Refer to
“Rear Sprocket / Rear Sprocket Mounting Drum
Removal and Installation: ”.
6) Install the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation: in
Section 2D”.
(A)
I649G1310018-02
(B)
I649G1310019-02
I649G1310020-01
(A) (A)
I649G1310022-02
I649G1310021-01
To Next Page
Loading...
