Suzuki 2005 GSF1200 - Page 266

2C-11 Rear Suspension:
Installation
CAUTION
!
The removed bearings must be replaced with
new ones.
1) Press the swingarm cushion rod bearings with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84521 (Bearing installer set)
2) Install the center spacer.
3) Press the bearings into the swingarm pivot with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside
Special tool
(B): 09941–34513 (Steering race installer)
4) Apply SUZUKI SUPER GREASE “A” to the bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the swingarm. Refer to “Swingarm / Cushion
Rod Removal and Installation: ”.
6) Install the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation: in
Section 2D”.
(A)
I649G1230038-02
(B)
I649G1230039-03
I649G1230044-01