5B-4 Manual Transmission:
20) Loosen the crankcase bolts (crankshaft tightening
bolts) in descending numerical order and then
remove them.
NOTE
Two allen bolts are located at position “A” to
tighten the crankshaft.
21) Remove the oil return pipe (11).
22) Separate the crankcases, upper and lower.
CAUTION
!
• Make sure that all of the bolts are removed.
• Do not allow the crankshaft journal
bearings to drop out of the lower
crankcase.
NOTE
If it is difficult to separate the crankcase
halves, set the proper bolt and nut to the
crankcase by separating the upper and lower
crankcase halves, as shown in the
illustration.
23) Remove the countershaft assembly (12) and
driveshaft assembly (13).
24) Remove the C-rings (14) and bearing pins (15).
NOTE
Do not lose the C-rings and bearing pins.
25) Hold the gearshift forks (16) and draw out the
gearshift fork shaft (17) from the lower crankcase.
“A”
11
“11”“7”
“12”
“8”
“4”“2”
“3”“1”“5”“9”
“6”“10”
I649G1520009-02
I649G1520010-03
I649G1520011-01
12
13
I649G1520079-01
14
14
15
15
I649G1520013-01
16
17
I649G1520014-01
To Next Page
Loading...
