Suzuki 2005 GSF1200 - Page 349

Manual Transmission: 5B-11
Left Oil Return Pipe and Oil Sump Filter
• Install the left oil return pipe (1).
• Install a new O-ring (2) and shim (3).
• Install a new gasket and the oil sump filter (4).
CAUTION
!
Replace the gasket and O-ring with new ones
to prevent oil leakage.
Oil Pan
• Install a new gasket and the oil pan. Tighten the oil
pan bolts to the specified torque.
Tightening torque
Oil pan bolt: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
CAUTION
!
Replace the oil pan gasket with a new one to
prevent oil leakage.
NOTE
Install a new gasket washer (1) to the oil pan
bolt as shown.
CAUTION
!
Use a new gasket washer (1) to prevent oil
leakage.
Bearing Retainer
• Apply a small quantity of THREAD LOCK “1342” to
the two screws.
: Thread lock cement 99000–32050 (Thread
Lock Cement 1342 or equivalent)
• Install the countershaft bearing retainer (1).
Gear Position Switch
• Install the gear position switch.
NOTE
When installing the gear position switch, be
sure to install the springs (1), switch contact
(2) and O-ring (3) properly.
CAUTION
!
Replace the O-ring (3) with a new one.
1
2
3
4
I649G1520035-01
I649G1520036-01
1
I649G1520037-01
1
I649G1520038-02
1
2
3
I649G1520039-02