Suzuki 2005 GSF1200 - Page 377

Clutch: 5C-15
4) Remove the thrust washer (3), bearing (4) and clutch
push piece (5), and pull out the clutch push rod (6).
NOTE
If it is difficult to pull out the push rod (6), use
a magnetic hand or wire.
5) Hold the clutch pressure plate with the special tool
and loosen the clutch sleeve hub nut.
Special tool
(A): 09920–34820 (Clutch pressure plate
holder)
6) After removing the clutch sleeve hub nut, remove the
lock washer (7).
7) Remove the clutch diaphragm spring holder (8) by
removing the screws.
8) Remove the clutch diaphragm springs (9), clutch
diaphragm spring seat (10) and clutch pressure plate
(11).
9) Remove the clutch drive and driven plates along with
the clutch sleeve hub.
10) Remove the thrust washer (12).
3
4
5
I649G1530032-01
6
I649G1530033-01
(A)
I649G1530034-01
I649G1530035-03
9
11
10
I649G1530036-01
12
I649G1530037-01