Suzuki 2005 GSF1200 - Page 393

Steering / Handlebar: 6B-6
14) Remove the steering stem nut using the special tool.
NOTE
When loosening the stem nuts, hold the
steering stem lower bracket to prevent it from
falling.
Special tool
(C): 09940–14911 (Steering stem nut
wrench)
15) Remove the steering stem lower bracket.
16) Remove the dust seal (7) and steering stem upper
bearing (8).
GSF1200S
1) Support the motorcycle with a jack or a wooden
block.
2) Remove the front wheel assembly. Refer to “Front
Wheel Assembly Removal and Installation: in
Section 2D”.
3) Remove the front forks. Refer to “Front Fork
Removal and Installation: in Section 2B”.
4) Remove the brake hose clamp (1).
5) Remove the cable guides(2).
6) Remove the ignition switch using the special tools.
Special tool
(A): 09930–11920 (Torx bit (JT 40H))
(B): 09930–11940 (Bit holder)
7) Dismount the handlebars by removing the handlebar
holder set nuts.
NOTE
Place a rag on the fuel tank to prevent the
fuel tank scratched.
(C)
I649G1620016-02
7
8
I649G1620017-02
1
I649G1620018-01
2
I649G1620019-01
(A)
(B)
I649G1620020-02