Engine Mechanical: 1D-11
• Position the carburetor clamps as shown.
• After remounting the engine, route the wire harness, cables and hoses properly. Refer to “Wiring Harness Routing
Diagram: in Section 9A” and “Throttle Cable / Starter Cable Routing Diagram: in Section 1G”.
• Install the gearshift lever to the gearshift shaft in the correct position.
Gearshift lever height “J”
55 mm (2.2 in)
• Tighten the oil drain plug to the specified torque.
Tightening torque
Oil drain plug (i): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
I649G1170033-01
“J”
I649G1140029-02
(i)
I649G1140030-03
To Next Page
Loading...
