00-3 Precautions:
• Check the male connector for bend and female
connector for excessive opening. Also check the
coupler for locking (looseness), corrosion, dust, etc.
Fuse
• When a fuse blows, always investigate the cause,
correct it and then replace the fuse.
• Do not use a fuse of a different capacity.
• Do not use wire or any other substitute for the fuse.
Ignitor unit / Various sensors / ABS control unit / HU
• Since each component is a high-precision part, great
care should be taken not to apply any sharp impacts
during removal and installation.
• Be careful not to touch the electrical terminals of the
Ignitor unit and ABS control unit/HU. The static
electricity from your body may damage this part.
• When disconnecting and connecting the Ignitor unit
and ABS control unit/HU couplers, make sure to turn
OFF the ignition switch, or electronic parts may get
damaged.
• Never allow dust or water to contact the ABS control
unit/HU.
3. Coupler 4. Probe “A”: Where male terminal fits
3
4
4
“A”
I649G1000030-01
I649G1000001-01
I649G1000003-01
1. Ignition S/W
I310G1000008-01
1
I649G1000031-01
I649G1000004-01
To Next Page
Loading...
