3-62 ENGINE
• Remove the water jacket plugs 3.
• Remove the oil gallery plugs 4 (for lower crankcase side).
Installation
• Apply engine coolant to the O-ring of the water jacket plug 1.
99000-99032-11X: SUZUKI COOLANT (Except USA)
• Apply THREAD LOCK to the oil gallery plug 2.
99000-32050: THREAD LOCK “1342”
NOTE:
It is not require to apply THREAD LOCK when installing the
other removed oil gallery plugs.
• Tighten each plug to the specified torque.
1 Water jacket plug: 9.5 N·m (0.95 kgf-m, 6.9 lb-ft)
2 Oil gallery plug (upper crankcase):
18 N·m (1.8 kgf-m, 13.0 lb-ft)
3 Oil gallery plug (lower crankcase):
35 N·m (3.5 kgf-m, 25.5 lb-ft)
4 Oil gallery plug (cylinder head):
10 N·m (1.0 kgf-m, 7.0 lb-ft)
Use each new gasket or O-ring.
SAMPLE
To Next Page
Loading...
