ENGINE 3-67
*1: The number faces the intake side.
• Remove the bearing caps and measure the width of the com-
pressed plastigauge using the envelope scale. This measure-
ment should be taken at the widest part of the compressed
plastigauge.
Conrod big end oil clearance:
Standard: 0.032 – 0.056 mm (0.0013 – 0.0022 in)
Service Limit: 0.080 mm (0.0031 in)
• If the oil clearance exceeds the service limit, select the speci-
fied bearings from the bearing selection table.
• Check the corresponding conrod I.D. code number (“1” or “2”)
A.
• Check the corresponding crank pin O.D. code number (“1”,
“2” or “3”) B.
Bearing selection table
Conrod I.D.
*1
Crank pin O.D. B
Code 123
Conrod
I.D A
1 Green Black Brown
2 Black Brown Yellow
Code I.D. specification
1
38.000 – 38.008 mm
(1.4961 – 1.4964 in)
2
38.008 – 38.016 mm
(1.4964 – 1.4967 in)
SAMPLE
To Next Page
Loading...
