3-78 ENGINE
• Insert the right and left-thrust bearings with oil groove B fac-
ing the crank web.
NOTE:
Right-thrust bearing has green painting.
BALANCER SHAFT
• Install the thrust washers 1, 2 and oil seal 3.
• Apply a MOLYBDENUM OIL SOLUTION to each balancer
shaft journal and bearing lightly.
MOLYBDENUM OIL SOLUTION
• Set the balancer shaft so that its punch mark A is aligned
with the index B on the crankshaft.
CRANKCASE
• Clean the mating surfaces of the crankcases.
• Install the dowel pins 1 and O-ring 2 to the upper crank-
case.
SAMPLE
To Next Page
Loading...
