ENGINE 3-79
• Apply SUZUKI BOND to the mating surface of the middle
crankcase.
99104-31140: SUZUKI BOND “1207B” (USA)
99000-31110: SUZUKI BOND “1215” (Others)
NOTE:
Use of SUZUKI BOND is as follows:
* Make surfaces free from moisture, oil, dust and other foreign
materials.
* Spread on surfaces thinly to form an even layer, and assemble
the crankcases within few minutes.
* Take extreme care not to apply any BOND to the oil hole, oil
groove and bearing.
* Apply to distorted surfaces as it forms a comparatively thick
film.
• Tighten the crankshaft journal bolts (M9) in ascending order
of numbers assigned to these bolts. Tighten each bolt a little
at a time to equalize the pressure in the following two steps.
Crankshaft journal bolt: (M9)
Initial : 18 N·m (1.8 kgf-m, 13.0 lb-ft)
Final : 50°
1
2
3
4
5
6
7
8
9
10
SAMPLE
To Next Page
Loading...
