3-96 ENGINE
*1: Direction of outside
*2: Paint
DRIVE PLATE:
a No. 2 Drive plate....... 1 pc. [Black paint/I.D. 111 mm (4.4 in)]
b No. 1 Drive plate....... 8 pcs. [Purple paint/I.D. 111 mm (4.4 in)]
c No. 3 Drive plate....... 1 pc. [NIL/I.D. 118 mm (4.6 in)]
NOTE:
No.3 drive plate can be distinguished by the inside diameter
(I.D.).
DRIVEN PLATE: (d + e + f = Total 9 pcs)
d No. 1 Driven plate (Thickness): 2.3 mm (0.091 in).....8 – 9 pcs.
e No. 2 Driven plate (Thickness): 2.0 mm (0.079 in).....0 – 1 pc.
f No. 3 Driven plate (Thickness): 2.6 mm (0.102 in).....0 – 1 pc.
• Install the pressure plate H.
NOTE:
When install the pressure plate, fit the convex part D of the
pressure plate onto the concave part E of the clutch sleeve hub.
• Install the clutch springs.
*1 *2
or
or
SAMPLE
To Next Page
Loading...
