FI SYSTEM DIAGNOSIS 4-69
Step 1 (When indicating P1654-H:)
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. (5-3)
3) Check the STP sensor coupler for loose or poor contacts.
If OK, then check the STP sensor lead wire continuity.
4) Disconnect the STP sensor coupler.
5) Check the continuity between Y/W wire B and Red wire A.
If the sound is not heard from the tester, the circuit condition
is OK.
6) Disconnect the ECM coupler.
7) Check the continuity between Y/W wire B and terminal J.
8) Also, check the continuity between B/Br wire C and terminal
S.
STPS lead wire continuity:
Continuity ()
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Continuity test ()
Is the continuity OK?
9) After repairing the trouble, clear the DTC using SDS tool.
(4-27)
1
1
!
YES Go to Step 2.
NO Y/W wire shorted to VCC, or B/Br wire open
1
!
ECM coupler (Harness side)
(Black)
(Gray)
SAMPLE
To Next Page
Loading...
