4-70 FI SYSTEM DIAGNOSIS
Step 1 (When indicating P1654-L:)
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. (5-3)
3) Check the STP sensor coupler for loose or poor contacts.
If OK, then check the STP sensor lead wire continuity.
4) Disconnect the STP sensor coupler.
5) Check the continuity between Y/W wire B and ground.
6) Also, check the continuity between Y/W wire B and B/Br wire
C. If the sound is not heard from the tester, the circuit condi-
tion is OK.
7) Disconnect the ECM coupler.
8) Check the continuity between Y/W wire B and terminal J.
9) Also, check the continuity between Red wire A and terminal
A.
STPS lead wire continuity:
Continuity ()
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Continuity test ()
Is the continuity OK?
10)After repairing the trouble, clear the DTC using SDS tool.
(4-27)
1
1
]
YES Go to Step 1 (4-68) and go to Step 2.
NO
Red or Y/W wire open, or Y/W wire shorted to
ground
1
!
ECM coupler (Harness side)
(Black)
(Gray)
SAMPLE
To Next Page
Loading...
