FI SYSTEM DIAGNOSIS 4-71
Step 2
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. (5-3)
3) Disconnect the STP sensor coupler.
4) Check the continuity between each terminal and ground.
STP sensor continuity: ∞ Ω (Infinity)
(Terminal – Ground)
5) If OK, then measure the STP sensor resistance at the wire
terminals (between Yellow wire A and Black wire B).
6) Close and open the secondary throttle valve by finger, and
measure the valve closing and opening resistance.
STP sensor resistance
Secondary throttle valve is closed: Approx. 0.5 kΩ
Secondary throttle valve is opened: Approx. 3.9 kΩ
(Yellow A – Black B)
7) If OK, then measure the STP sensor resistance at the wire
terminals (between Blue wire c and Black wire B).
STP sensor resistance: Approx. 4.69 kΩ
(Blue c – Black B)
09900-25008: Multi-circuit tester set
Tester knob indication: Resistance (Ω)
Are the continuity and resistance OK?
8) After repairing the trouble, clear the DTC using SDS tool.
(4-27)
2
2
2
2
YES Go to Step 3.
NO
• Reset the STP sensor position correctly.
• Replace the STP sensor with a new one.
2
SAMPLE
To Next Page
Loading...
