FUEL SYSTEM AND THROTTLE BODY 5-19
• Apply thin coat of the engine oil to the new O-ring 3 and
cusion seal 4.
• Apply thin coat of the engine oil to the new O-rings 5.
• Install the joints.
• Install the fuel injector 6 by pushing it straight to the delivery
pipe 7.
NOTE:
Align the boss E of the injector with the groove F of the delivery
pipe.
• Apply thin coat of the engine oil to the new O-rings.
• Assemble the fuel delivery pipes as shown.
Fuel delivery pipe mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
NOTE:
The screw section G of joint is turned to a #2 side and the
longer one H body is turned to the injector side.
Replace the cushion seal and O-ring with the new
ones.
Replace the O-ring with the new ones.
Never turn the injector while pushing it.
* Replace the O-rings with the new ones.
* Never turn the fuel delivery pipes while pushing it.
#2
#2
#2
#3
#2
#2
#2
#3
SAMPLE
To Next Page
Loading...
