SERVICING INFORMATION 10-19
Clamp (After binding the lead wires, cut the clamp end.)
Clamp (After binding the lead wires, cut the clamp end.)
Clamp
10 mm (0.4 in)
Immobilizer label
(E-02, 19, 24)
Locate the junction of the wire harness to the
center of the headlight.
Wire harness protector tape
IAT sensor
STP sensor
CKP sensor
Guide
TP sensor
Backside of the fuel tank
Oil pressure switch
Clamp
Brake light switch
Cooling fan lead wire
STV actuator
Backside of the headlight
SAMPLE
To Next Page
Loading...
