Suzuki GSX-R1000K5 - Page 67

ENGINE 3-13
• Install the engine sprocket and the washer.
• Apply a small quantity of THREAD LOCK to the driveshaft
thread portion.
99000-32050: THREAD LOCK “1342”
• Tighten the engine sprocket nut 1 to the specified torque.
 Engine sprocket nut: 115 N·m (11.5 kgf-m, 83.0 lb-ft)
• Install the speed sensor rotor 2.
• Tighten the speed sensor rotor bolt 3 to the specified torque.
 Speed sensor rotor bolt: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
• Apply SUZUKI SUPER GREASE “A” to the clutch push rod
end.
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the engine sprocket cover.
NOTE:
When installing the engine sprocket cover, align the clutch
release cylinder hole with the end of clutch push rod.
• Tighten the speed sensor bolt 4 to the specified torque.
 Speed sensor bolt: 4.5 N·m (0.45 kgf-m, 3.0 lb-ft)
• Install the gearshift lever as shown.
A Footrest
B 50 – 60 mm (1.97 – 2.36 in)
SAMPLE