ENGINE 3-19
• Hold the clutch sleeve hub with the special tool.
09920-53740: Clutch sleeve hub holder
• Remove the clutch sleeve hub nut.
• Remove the conical spring washer 9, washer 0 and clutch
sleeve hub A.
• Remove the wave spring washers B and clutch lifter driven
cam C.
• Remove the clutch lifter drive cam D and washer E.
• Remove the spacer F and bearing G.
• Remove the primary driven gear assembly H.
NOTE:
If it is difficult to remove the primary driven gear, rotate the
crankshaft.
SAMPLE
To Next Page
Loading...
