3-20 ENGINE
• Remove the thrust washer I.
• Remove the oil pump drive gear J from the primary driven
gear assembly K.
OIL PUMP
• Remove the snap ring 1.
• Remove the oil pump driven gear 2.
NOTE:
Do not drop the snap ring 1 into the crankcase.
• Remove the pin 3 and washer 4.
• Remove the oil pump 5.
NOTE:
Do not drop the pin 3 and washer 4 into the crankcase.
GEARSHIFT SYSTEM
• With the snap ring 1 and washer removed, remove the gear-
shift shaft assembly 2.
• Remove the gearshift cam plate bolt 3 and gearshift cam
plate 4.
• Remove the gearshift cam stopper 5.
SAMPLE
To Next Page
Loading...
