ENGINE 3-41
VALVE AND VALVE SPRING REASSEMBLY
• Install the valve spring seat.
• Apply MOLYBDENUM OIL SOLUTION to the oil seal 1, and
press-fit it into position.
MOLYBDENUM OIL SOLUTION
• Insert the valve, with its stem coated with MOLYBDENUM
OIL SOLUTION all around and along the full stem length with-
out any break.
MOLYBDENUM OIL SOLUTION
• Install the valve spring with the small-pitch portion A facing
cylinder head.
B Large-pitch portion
C UPWARD
D Paint
• Put on the valve spring retainer 2, and using the valve lifter
and protector 3, press down the spring, fit the cotter halves
to the stem end, and release the lifter to allow the cotter 4 to
wedge in between retainer and stem.
09916-14510: Valve lifter
09916-14530: Valve lifter attachment
09916-84511: Tweezers
Do not reuse the removed oil seal.
When inserting the valve, take care not to damage the
lip of the oil seal.
SAMPLE
To Next Page
Loading...
