ENGI
NE
127
J.
In
stall the len-hand crankcase cover (
Figure
230) and bolts.
4.
Tighten the left-hand crankcase
co\c
r bolts se-
curely.
5.
Install the bolt (
Figurl'
229) securing thc stator
assembly electrical
cable
to
the external sh ift mech-
anism eover.
6.
Make sure the drivc belt is properly mcshed with
the driven pulley on the rear whcel.
7.
Mcsh thc drive belt onto the drive pulley and in-
stall these 2 parts as an assembly onto thc transmis-
sion mainshaft (FiguTl' 233
).
8.
Prior to installing the lockwasher. partially bend
up one side
(
Figure
234
).
It is difficult to reach the
lock washer within the reccss
of
the drivc pulley
once the
drivc pulley nut is installed.
9.
Install a new lockwashcr and the nut.
CAUTION
III
Sfep
10.
'he
drire
bellmusl
be Prof}-
er~\'
meshed lI"ilh
bOlh
Ihe dril"/! (Illd
drjrell
pulleys.
If
1101,
Ihe bell leelfl
may be
slri!}ped while lightening Ifle
drjre
pul/t'.r
11111
lI"ilh
Ihe n'
lIr
bmke
applied.
10.
Pull the rear wheel toward the rear with the
drive belt properly engaged with both the
drive and
driven pulleys.
Ti
ghten the drive belt adjuster bolts
temporaril
y.
I
I.
Havc an assistant apply the rear brake and
tighten the drive pulley
nut to the
to
rque specifica-
tion listed in Tabll' 2.
12.
Continue
to
bend up one section
of
the ncw
lock washer onto one
of
the flats
on
the drivc pulley
nut.
To Next Page
Loading...
