U6
18,
Loosen the rear axle nut (Figure 225).
1
9.
Loosen the drive belt adjuster nut (A, Figure
226) and loosen the adjust bolt (B. F
igur
e 226) on
each side
of
the swing arm so the wheel can
be
moved forward for maximum belt s
la
c
k.
Pu
sh the
rear wheel forward.
20. Careful
ly
pull
th
e drive pullcy (A.
Figure
227)
and drive belt (8.
Figure
227)
off
the trans
mi
ssion
mainshaft.
21.
Remove
th
e drive pullcy and drive belt.
22. Remove the tie wrap (Figure 228) securing the
alternator electrical cable and emission control
hoses
to
the frame.
NOTE
Slep 23 anti Srep
24
are sh
ow
n wilh the
engine removed from llle frame for
clarity.
II
is nor necessary
to
remove
the engine
/0
perform this procedure.
23.
Remove the bolt (
Figure
229) securing
th
e
stat
or
assembly electrical cable to
th
e external shift
mechanism cover.
24. Remove the bolts securing the left-hand
crankca
se
cover (Fig
ure
230) assembly and remove
the cover and gasket. Don't lose the locating dowels
in
the crankcase.
Installation
I. Make
su
re the locating dowels
(F
igure 231) are
in
place.
2. Insta
ll
a new left-hand crankcase cover gasket
(
Figure
232)
CHAPTER
FOUR
-
To Next Page
Loading...
