ELEC
TRI
CAL SYSTEM
®
®
®
223
1
0.
Clean all grease. dirt and carbon from all
components.
1
1.
Inspect the slarter components
as
described
in
Ih
is
chapter.
Ass
embl
y
1.
On models so equipped. install the insulator
ring and align the notch with the locating tab on
the case (Fig
ur
e 33).
2. Install the positive
(+)
brush holder (f ig
ur
e
32).
3.
Install the inner
in
sulator (Fig
ur
e 31).
4.
In
sta
ll
the bo
lt
(
Figur
e 30) and install the
0-
ri
ng (Fig
ur
e 29).
5. Install the outcr
bu
shing and nut (Fig
ur
e 28)
securing the brush assembly
to th
e
casco
6.
Insert the armature coil assembly (Fig
ur
e 27)
in
to the Icft-hand end
of
the case.
7.
Release the springs from
th
e brushes (
fig
ure
34) in the negative
(-)
brush holder.
8.
Move the positive
(+)
brushes
OUI
so the
negative
(-)
brush holder c
an
be
inSla
li
ed over
them.
Carefu
ll
y align the positive brush wires with
the notches in the negati
ve
brush holder.
9.
Insta
ll
t
he
negative (-) brush holder into the end
of
the case. Align the notch
in
the holder with the
locating tab (
Figur
e 35) in the case.
1
0.
Install the positive
(+)
brushes into their
receptacles in the negative brush ho
ld
er.
11
. Rotate the end
of
the spring counterclockwise
and index the spring e
nd
into the backside of the
brush. Repeat for all 4 brushe
s.
I •
To Next Page
Loading...
