ENGINE 79
4. With the groove aligned with the notch, ji
gg
le
both rocker a
rm
s a
nd
make sure botli have free
play.
If
one rocker arm
is
still
und
er tension.
ro
tate
the engine an additional 1
80
0
until both rocker
arms
hav
e free
play.
5.
Remove the engine from the frame
as
described
under
Engine Rem
omillnswllatioll
in
this chapter.
6.
Remo
ve
the right-hand crankcase cover as de-
scribed
in
this cha
pt
er.
CAUTION
In tlie following step, do
1101
remove the
bolt
Willi
a con
cQI'e
head
alld marke(J
with an
'iI"
(
Fi
g
ur
e 32).
n,is
bolt
secures the exhaust \'Glre rocker arm
shaft
in place
01,,1
IIIust
be
left i
ll
place
at this time.
7.
Usi
ng
a crisscross
pa
tt
ern, loosen, then remove
the
bolts securi
ng
the
cy
linder head cover
(F
igure
33)
to
the cylinder head.
8. Remove the cylinder head cover. Don't lose the
locating dowels.
9.
Remove the loose bolt (
Figur
e
34
) used
to
hold
the lefl-hand top cover in place.
10.
Remo
ve
the cylinder head plug (Fi
gure
35)
from left-hand side of the
cy
linder head.
11.
Remove the circlip (Figure
36
) securing the
camshaft chain tensioner adjuster
to
the threaded
st
ud
.
To Next Page
Loading...
