ENGINE
@
"'
dril'e chain and keep it
10111
while
rotating the crankshaft. Make certain
that Ihe drive chain is positioned
on
the
crankshaft liming sprocket.
If
this is
lIot
lJone.
the drive chain call
become
kinked
and
call
damage
bOlh the dril'e
chain and the timing sprocket on the
crankshaft·
81
23.
Remove
the
head seal cap (
Fi
gure 42)
from
the cylinder head.
24. Using a crisscross pallern. loosen the bolts
(Fig
ur
e 43) securing the cylinder head
to
the
crankcase studs.
Re
move the nuts and copper
washers.
25. Remove the nuts securing the from (
Fi
g
ur
e 44)
and rear (t"ig
ur
e 4
5)
of the cylinder head to the
cylinder.
26.
Remove
the
bolt and washer (Fig
ur
e 46)
securing the camshaft chain Icnsioner to the cyl-
inder
head
.
27
. Loosen the cylinder head (A. Fig
ur
e 4
7)
by
lapping around the perimeter with a rubber
or
soft-
®
A
To Next Page
Loading...
