86
30. Make sure the locating dowels (Figu
re
67) are
in place in the
cy
linder head.
3
1.
Install the loose boll (Fig
ur
e 68), used to hold
the left-hand
lOp
cove
r.
into position in the front
le
ft-hand corner.
NOTE
Th
e
c),
linder head sealing surface must
be thoroughly cleaned using the
following method
to
help prevent
an
oil
leak.
32
. Clean
th
e sealing surface as
fo
ll
ows:
a. Rem
ove
the old gaskets and clean off a
ll
gas-
ket sc
al
er
re
sidue from the
cy
linder head
co
ver.
b. Clean the surface with aerosol electrical
co
ntact cleaner and wipe dry with a lint-free
cloth.
c.
Appl
y a coat of Three
Bond
No.
1
216
to
se
aling
surface of
th
e
cy
linder head cover. Do
no/
apply sealant to the rounded surfaces of the
carnshoft bearing
journal
surfaces.
33.
In
stall a new Q-ring seal (Fig
ur
e 69) in the
cy
linder head cover.
34. Make sure the wire mesh (Fig
ur
e 70) is
in
place
in
the crankcase breather space.
35.
In
stall the cylinder head cover onto the
cy
lin-
der head .
36.
Ref
er
to Figu
re
71 for cylinder head cover bolt
length placement.
Be
sure
to
place a sealing washer
under all bolt heads followed
by
an asterisk (*) in
Figu
re
71.
In
stall the bolts securing the cyl
in
der
head cover. The only black
bolt (length 130 mm)
is
in
stalled at
th
e right-hand resr
co
rner
.
CHAPTER
FOUR
®
@
To Next Page
Loading...
