ENGINE 3-75
FINAL ASSEMBLY
• After adjusting the gear backlash and tooth contact correctly,
remove the front and rear output shafts and drive bevel gear.
• Clean off any machinist’s dye or paste from the gear teeth,
and lubricate the teeth with engine oil.
• Tighten the rear output shaft nut and drive bevel gear nut to
the specified torque.
# Rear output shaft nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
Drive bevel gear nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
( 09930-73150: Output shaft holder (!3-52)
• Stake the collar of the nut
1 into the notch in the shaft.
\
NOTE:
After the backlash and tooth contact have been checked or
adjusted, reassemble the universal joint. (!3-70)
To Next Page
Loading...
