4-36 DRIVE TRAIN
• Install the new seal washer to the cover bolt
A.
"
• Tighten the cover bolts to the specified torque in a crisscross
pattern.
( Parking cam cover bolt: 10 N·m (1.0 kgf-m, 7.3 lb-ft)
• Apply the grease to the pin and install the parking cam stop-
per
1.
• Tighten the parking cam stopper
1 to the specified torque.
( Parking cam stopper: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
REAR DRIVE INSTALLATION
Install the rear drive in the reverse order of removal. Pay atten-
tion to the following points:
• Coat the new O-rings with grease and install them into the
grooves in the gear case and cover.
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Apply grease to the splines of the axle and rear drive shaft
splines too.
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Apply THREAD LOCK SUPER “1303” to the axle housing
bolts and tighten them to the specified torque.
) 99000-32030: THREAD LOCK SUPER “1303”
( Axle housing bolt: 55 N·m (5.5 kgf-m, 40 lb-ft)
Replace the seal washer with a new one.
To Next Page
Loading...
